2024 Befco Hurricane H40-S 60

2024 Befco Hurricane H40-S 60

Features may include:

• Cutting heights: from 3/4" to 2 3/8"

• Dual rear roller mounting position, inside or outside the cutting chamber

• Manual belt tensioner without spring loaded idlers

• Choice of fine cut blades at 90° angles, reverse “Y” blades, paddle blades or hammer type blades

• Dethatching blades available

• Adjustable cutting height roller with scraper or self cleaning roller when mounted inside the cutting chamber

• Heavy duty shielded PTO shaft (1 3/8" ASAE cat. 3)

• Sealed rotor bearings

• Front and rear tractor mounting

• Heavy duty, one piece balanced steel pulleys

• Two heavy duty reinforced notched belts (SPBX)

• 3 Point linkage, cat. 1

• Standard front rubber safety shielding

• Reversible three point hitch for front and rear tractor mounting.

• When roller is mounted in the standard position most of the cut grass will be discharged in front of the roller.

• If the roller is mounted in the forward position, most of the cut grass will be discharged behind the roller. Mounting the roller in the forward position allows for the blades to prevent grass build up on the rear roller.

• Note: When using rear roller in the forward position, the roller scraper will need to be removed

• Our manually loaded belt tensioning system has allowed us to remove idlers which often turn out to be the root cause of most belt failures.

• H40-S mowers are equipped standard with heavy duty individually balanced steel pulleys and SPBX type reinforced notched belts. Pulleys have over 180° belt coverage without the use of idlers.

• Our sealed rotor bearings never require external grease.

• The low profile of the rotor supports means the operator can mow closer to obstacles without risking to impact the supports against foreign objects.

• Clockwise rotor rotation allows cut debris to be thrown up and around the rotor and then straight down into the ground, reducing the risk caused by thrown objects.

• Only BEFCO offers you the choice of fine cut blades, dethatching blades, reverse “Y” blades, paddle blades or hammers blades allowing the operators to set up the unit specifically for their application.